Sodick Mark25 AP500 program run

Hi friends,

I have used both a newer and older Sodick wirecuts. But I cannot find or figure out how to cycle start a program. I can load it in edit, graph it, select material conditions and other functions but how do I get it to run?? I can run it once from “MDI” “LOAD” but this doesn’t repeat and I know there is a better way as a couple of times I fumbled into it but don,t know what i did. I have both machine and control manuals but can’t find the clue.

Best regards to all of you, Tom

1 Like

@TomSparky On my Sodick wire after you load it and graphic it on my LN2 control all I do is hit the run tab and press the green enter button.